Safety
Materials that never go in the laser.
A settings page is for a material a maker already treats as laser-compatible. If you cannot name the plastic, it does not go in for a test square.
What the makers wrote
- OMTech’s material article says most generic faux leather is PVC, and laser-cutting PVC generates toxic chlorine gas and hydrochloric acid. It also says chrome-tanned leather releases hazardous off-gases and should not be engraved. Use vegetable-tanned leather, or a synthetic that is actually sold as laser-safe. That link is on OMTech’s store site, so it is marked as a possible affiliate link. Disclosure.
- Glowforge’s Performance safety page says vinyl can be mistaken for a safe plastic and emits harmful smoke. It names vinyl, PVC, ABS, and HDPE as plastics that can melt or release toxic or corrosive fumes. It says galvanized metal can release hazardous gases. It says copper and chrome can reflect the laser and damage the machine. It says some plywood glues, inks, adhesives, dyes, and paints are not laser-compatible.
- Glowforge’s custom-materials FAQ says the company will not give settings for a material it has not approved, and it repeats that vinyl is not laser-compatible.
- The same Glowforge safety page says smoke and fumes can include carbon monoxide, and that fumes from a material that is not laser-compatible may not be controlled by exhaust or filtration.
- Glowforge’s spec page says a Performance machine needs their filter or a window within 8 feet. The xTool F1 support introduction describes a built-in fan. A fan is not a reason to test a forbidden plastic.
The short list this site will not give settings for
- PVC, vinyl, and unknown plastics, including a lot of faux leather.
- ABS and HDPE, named by Glowforge.
- Chrome-tanned leather, named by OMTech.
- Galvanized metal, named by Glowforge.
- Mirror-bright copper and chrome, because Glowforge says they can reflect a CO2 beam.
An older OMTech file, their cutting-parameter PDF, still prints speeds for PVC. This site does not repeat those numbers. The later OMTech article is the warning, and it wins.
Ventilation on a job that is allowed
Wood, cast acrylic, vegetable-tanned leather, slate, anodized aluminum, and glass are the materials in the first set. They still make smoke or dust. Exhaust the job outdoors or through a filter the maker rates for it. Do not run the laser in a closed room and hope a cracked window is enough. Glowforge’s own page is the citation for carbon monoxide in laser smoke.
Slate makes stone dust. The Atomm slate project used on the F1 settings page tells you to wash the dust off and to have an exhaust fan or an open window. That is a dust note, not a chlorine note.
Questions people ask
Why does this site refuse to print a speed for PVC?
OMTech’s leather article says laser-cutting PVC generates toxic chlorine gas and hydrochloric acid, which can hurt you and ruin mirrors and rails. Glowforge’s safety page says vinyl and PVC can release toxic or corrosive fumes that exhaust may not control. An old OMTech cutting chart still has PVC rows. This site does not copy those speeds.
Is a small filter enough?
Glowforge says smoke and fumes from a laser can include carbon monoxide, and that some materials make fumes that cannot be controlled by exhaust or filtration. Their Performance series spec says to vent with their filter or a window within 8 feet. A hobby filter does not make a forbidden plastic safe.