Library

Settings

One machine and one material. The table is a place to start a test grid, not a promise that the first square is the one you keep.

Machine × material · Settings Glowforge Pro settings for anodized aluminum

Glowforge will not publish a custom anodized preset. Forum reports span 335 to full speed. None of them name the Pro, so each row is a starting estimate.

Machine × material · Settings OMTech 60W settings for 1/8 inch birch plywood

OMTech prints 10–15 mm/s at 80–90% for 1/8 inch plywood on a 40–60W CO2, and a different 3 mm board row at 95%.

Machine × material · Settings xTool F1 settings for engraving slate

An Atomm project prints an F1 diode start of 90–100% power, 150 mm/s, and 140 lines per cm. The project itself was made on a D1 Pro.

Machine × material · Settings OMTech 60W settings for 3 mm cast acrylic

OMTech's 60W chart says 15 mm/s optimal at 95% for 3 mm acrylic. Their blog says 10–15 mm/s at 65–75% for a 60–80W CO2.

Machine × material · Settings OMTech 60W settings for vegetable-tanned leather

OMTech's 60W engrave row is 100 mm/s at 10–15%. Their 40–60W cut for 3–5 ounce veg-tan is 25–30 mm/s at 40–50%, one pass.

Machine × material · Settings OMTech 60W settings for engraving glass

OMTech's 40–60W CO2 glass row is 300 mm/s at 20% power, with a 0.1 mm line interval. It is an engrave, not a cut.