Helper
Build a test grid before you trust a number.
This page only lays out squares. It does not know the right setting for your sheet, and it does not talk to your laser. You run the grid on scrap, then you pick the square that is dark enough and not burned.
Your grid
Line list for xTool Creative Space
If your version has a material test array, match the lowest power, highest power, lowest speed, highest speed, and the counts above. If it does not, each line below is one square you can run on scrap.
How to use it in LightBurn
LightBurn has its own material test. Match the same lowest and highest power, the same lowest and highest speed, and the same number of columns and rows. This page is the picture of that grid. It does not export a LightBurn file, and it does not start the laser.
Read the grid the way xTool describes a material test: low power plus high speed is often too light, and high power plus low speed is often burned. Pick a clear square with clean edges, not the darkest one. Then run that one setting on another scrap before the real piece.
What this helper will not do
- It will not invent a recommended setting for a material. That lives on a settings page, with a source.
- It will not send the numbers to a server. The grid is built in this browser tab.
- It will not tell you a plastic is safe. If you cannot name the plastic, it does not go in the machine. See safety.