Material · Materials

Birch plywood, including 1/8 inch

Birch plywood is the usual craft sheet. Makers often publish a 3 mm or 1/8 inch row that also covers balsa, so the species still needs a test.

· About 2 min read

Also called
Baltic birch, 3 mm ply

Settings written for this material

Craft tables say “plywood” and mean a light, even sheet. Baltic birch is the one most shops buy in 1/8 inch, 1/4 inch, and 1/2 inch. OMTech’s wood article does not use the words “Baltic birch.” Its 1/8 inch row says “plywood/balsa” for a 40W to 60W CO2. Balsa is much softer than birch. That is why the OMTech settings page prints the range and tells you to start the test at the gentle end of it.

What the laser is doing

A CO2 beam cuts wood by burning a narrow line. Glue between the plies can resist more than the wood, or it can be a glue you should not burn. Glowforge’s custom-materials FAQ says some plywood glue is not laser-compatible and tells you to ask the manufacturer. If the sheet is construction plywood from a home center, this page does not give you a speed. Know the glue first.

xTool’s F1 introduction says the diode can cut wood, up to 8 mm, and it does not print a birch speed. There is no F1 birch page on this site yet. Do not copy the OMTech millimeter-per-second row onto a diode. The machines are not the same kind of laser.

Air, focus, and char

OMTech’s wood section says air assist matters, and it names a strong air supply rather than a tiny pump. It also says not to focus on the top surface for a cut. Drop the focal point about halfway into the thickness. Masking tape or transfer tape on the faces keeps the smoke stain off the wood. Knots and voids in cheap ply will not fall out on the first pass even when the rest of the line does.

If the edge is black and the piece is oily, you had too much heat: more speed, less power, or more air. If the piece does not fall out, you had too little. The settings page walks through both.

Sheets of 1/8 inch birch are a normal Amazon search if you do not have a local plywood dealer: 1/8 inch birch plywood. The search is not a grade. Read the listing for “Baltic birch” and for a laser-safe or interior glue if the seller says so.

Questions people ask

Is 1/8 inch the same as 3 mm?

1/8 inch is 3.175 mm. A chart that says 3 mm is close, and it is not the same sheet. If the 3 mm row almost cuts through, the extra fraction of a millimeter is a reason to slow down, not a reason to invent a new speed.

Can every plywood go in the laser?

No. Glowforge says some plywood glue is not laser-compatible, and that you should check the maker or the safety data sheet. Exterior plywood and anything with an unknown glue line stay out until you know.

Sources

  1. Material settings for laser engravers — OMTech
  2. Non-Proofgrade materials FAQ — Glowforge
  3. xTool F1 product introduction — xTool