Material · Materials

Cast acrylic, and how it differs from extruded

Cast acrylic is the one that engraves frosty. Extruded acrylic cuts, and OMTech says the edge is more likely to melt and look gummy.

· About 2 min read

Also called
Plexiglass, PMMA

Settings written for this material

Acrylic here means PMMA, the plastic people call plexiglass. It is not polycarbonate, and it is not PVC. If the scrap is a scrap of “plastic,” it does not go in the machine. Glowforge’s spec page lists plexiglass (acrylic) among materials the CO2 can cut and engrave. Their safety page, linked from safety, says many other plastics are not safe.

Cast and extruded

OMTech’s acrylic section draws the line this way:

  • Cast acrylic is the one they tell you to use for a clean polished edge and for a frosty white engrave.
  • Extruded acrylic will cut, and they say it tends to melt more, with an edge that can look gummy or flared.
  • For a clear engrave, mirror the art and engrave the back so the front face stays smooth.
  • Leave the paper or plastic masking on. It takes the smoke stain instead of the sheet.

Those are material facts, not speeds. Speeds for a 60W CO2 on 3 mm sheet are on the OMTech acrylic page. That page also says the chart assumes a lot of power, and the blog’s 60W to 80W band is lower. You test both ideas on scrap. You do not blend them into a third number.

Air and flame

OMTech says acrylic wants steady air while cutting, so the melted plastic clears and the edge does not flame. The same article says to turn the air down for an engrave, or the frost can look cloudy. Their cutting PDF says to keep the air on the face modest, or blow from the side, so the edge stays smooth, and to keep air under the sheet so it does not catch. Leave the masking on.

A 1/8 inch (3 mm) cast sheet is the usual first buy: cast acrylic sheet. Confirm the listing says cast if you care about the white engrave. Extruded is a different test.

Questions people ask

How do I tell cast from extruded?

The sheet's label or the dealer's product line is the reliable way. A frosty white engrave is what OMTech says you get from cast acrylic. Extruded acrylic often engraves clear or grey. Do not guess from the color of the sheet alone.

Will a diode cut clear acrylic?

OMTech's diode note says blue light passes through clear acrylic, so people switch to opaque acrylic or many slow passes. xTool's F1 page says the diode cuts some dark opaque acrylic, and it lists black acrylic under the infrared laser. Clear cast acrylic is a CO2 job.

Sources

  1. Material settings for laser engravers — OMTech
  2. xTool F1 product introduction — xTool
  3. Glowforge Performance series tech specs — Glowforge