Material · Materials
Glass for engraving only
Glass is an engrave. A CO2 marks it. A blue diode goes through clear glass unless you add a dark coating. Nobody on this site is cutting glass.
- Also called
- clear glass, tile
Settings written for this material
Glass engraving is a frosted mark in the surface. It is easy to crack a thin piece, and it is easy to chip the art into a sandy mess if the heat is too high. Glowforge’s spec page lists glass under engrave only, with marble and ceramic tile.
OMTech’s glass section separates the lasers:
- A CO2 in the 40W to 60W band is given one row: 300 mm/s, 20% power, 0.1 mm interval. That row is quoted on the OMTech glass page. The MF1624-60 is a 60W tube, at the top of the band.
- A 10W diode row on the same page is 35 mm/s at 90% to 100%. That row is for a diode, and it assumes the coating they describe. It is not copied onto the CO2 settings page.
- Clear glass and a blue diode: the light passes through. OMTech says you must add a dark coating. xTool’s F1 introduction lists “dark glass” for the diode, not clear glass.
Heat
OMTech suggests a thin coat of black tempera, chalkboard paint, a damp paper towel, or a marking spray. The paper-towel method needs the air assist off so the towel does not dry out mid-job. That is their tip for the towel, not a second power setting. Any spray has to be fully dry, and flammable vapor does not belong in the laser room. Glowforge says not to store paint, acetone, gasoline, or alcohol in the same room as the machine.
If the mark is a pile of chips, or the glass cracks, you had too much heat in one place. If the mark is too light, the coat may be missing or the speed is high. Test a corner. Do not start with a customer’s window.
A small tile is easier to scrap than a bottle: glass tile blanks. Bottles need a rotary, and a rotary is a different setup this page does not number.
Questions people ask
Can I cut a glass ornament?
No. Glowforge lists glass as engrave-only. OMTech's glass section is about engraving and about keeping the glass from cracking. A cut speed for glass is not published on this site.
Why did my diode do nothing on a clear jar?
OMTech says a blue diode passes through clear glass. You have to add a dark coat, such as a thin layer of tempera or a marking spray, so the light has something to hit. A CO2 does not need that coat, though many people still use a damp paper towel to spread the heat.
Sources
- Material settings for laser engravers — OMTech
- Glowforge Performance series tech specs — Glowforge
- xTool F1 product introduction — xTool