Material · Materials
Vegetable-tanned leather
OMTech says to laser vegetable-tanned leather only. Chrome-tanned leather and most faux leather stay out because of the fumes.
- Also called
- veg-tan, tooling leather
Settings written for this material
Vegetable-tanned leather is hide tanned with plant tannins. It is the tooling leather sold by the ounce. Three to five ounce stock is about 1.2 to 2 mm. Eight ounce is about 3 mm. OMTech prints different cut rows for those two weights. The settings page keeps them apart.
What stays out
OMTech’s article is blunt. Chrome-tanned leather should not be lasered. Most faux leather is PVC, and laser-cutting PVC makes toxic chlorine gas and hydrochloric acid. Glowforge lists leather among materials a CO2 can cut, and their safety page says some leather is processed with chemicals that are not laser-compatible. “Leather” on a spec list is not permission for every hide in the shop.
xTool’s F1 introduction includes leather on the diode list for engraving and cutting. It does not say chrome-tan is fine. The OMTech warning still applies. There is no F1 leather settings page here yet, because this site does not have an F1 leather number with a source.
Smell, char, and tape
Lasered leather smells like burned hide. OMTech says that is normal for veg-tan, and they suggest masking tape on both faces, a damp hide if you want less char, and strong air. Those are technique notes from their article, not a second power number. If the edge chars into a brittle crust, you had too much heat. If the cut does not go through, the hide may be thicker than the row you used. Weigh a scrap or check the ounce stamp before you slow the job down.
A US search for the right hide: vegetable tanned leather. Read the tannage. If the listing does not say vegetable-tanned, do not buy it for the laser.
Questions people ask
What is chrome-tanned leather?
It is the process used on most garment and upholstery leather. OMTech says burning it releases hazardous off-gases that can hurt you and corrode the machine. Vegetable-tanned tooling leather is the kind their settings table is about.
Is faux leather ever safe?
Only if the seller says it is laser-safe and the safety data sheet agrees. OMTech says most craft-store faux leather is PVC, and PVC makes chlorine gas. A soft 'leatherette' is not a test square.
Sources
- Material settings for laser engravers — OMTech
- xTool F1 product introduction — xTool
- Glowforge Performance series tech specs — Glowforge